NexStor 4900F Series User Manual page 93

6 Connect the Fibre Channel data cable(s).
a
Connect a cable from the host first HBA FC port to the "H0" connector
on the right Host I/O card.
b
Connect another cable from the host second HBA FC port to the "H1"
connector on the left Host I/O card. Refer to the illustration below.
NexStor 4921F/4922F/4941F/4942F
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Host Server
Multi-Port Mirrored Single Host-Dual Connection Cabling Diagram
7 (Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN. Connect a second
CAT 5e ethernet cable from the second RAID Controller to another network
connection.
8
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
9 Power on your system, refer to "Powering On the Storage System" on
page 102.
This completes the setup and cabling of this configuration.
Chapter 3 - Setup and Installation
D1 D2 H0
FC HBA
FC HBA
Multi-Port Mirrored Single Host-Dual Connection Configuration
H1 H0 H1
NETWORK TEST
ONLY SERVICE
NETWORK TEST
ONLY SERVICE
79