Table of Contents
Advertisement
Chapter 3 - Setup and Installation
7
8
9
This completes the setup and cabling of this configuration.
62
Stand-Alone Dual Port Single Host Configuration
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN.
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
Power on your system, refer to "Powering On the Storage System" on
page 102.
Advertisement
Table of Contents
