Table of Contents
Advertisement
6
Connect the Fibre Channel data cable(s).
a
Connect a data cable from the host HBA FC port to the "H0" connector
on the right Host I/O card.
b
Connect another data cable from the host HBA FC port to the "H1"
connector on the left Host I/O card.
NexStor 4911F/4912F/4931F/4932F
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Host Server
Stand-Alone Dual Port Single Host Dual Connection Cabling Diagram
7
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN.
8
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
9
Power on your system, refer to "Powering On the Storage System" on
page 102.
This completes the setup and cabling of this configuration.
D1
D2
Stand-Alone Dual Port Single Host Dual Connection Configuration
Chapter 3 - Setup and Installation
H0
H1
H0
H1
TEST
NETWORK
ONLY
SERVICE
FC HBA
FC HBA
65
Advertisement
Table of Contents
