Table of Contents
Advertisement
11 Re-install the cooling fan module. Slide it into its open bay and ensure it
seats completely, and the release latch resets.
12 Re-install the power supplies. Slide each power supply into its empty bay
and ensure it seats completely, and the release latch resets.
13 Continue now with "Completing the Installation" on page 51.
Completing the Installation
1
Install the disk drives.
a
Remove each drive from its anti-static protective packaging. Inspect for
obvious damage.
b
Install each disk drive into a drive slot by aligning the drive carrier rails
with the grooves in the drive bay wall. Repeat this step to populate all
the required drive slots.
NOTE:
The drive carrier has tension clips in the rail to ensure a snug fit, so
it requires some force to seat the drive.
c
Install the front bezel. The bezel mounts to the two front post stud, one
on each mounting ear, and the bezel lip fits under the chassis top.
Installing Disk Drives
Chapter 3 - Setup and Installation
Completing the Installation
51
Advertisement
Table of Contents
