Table of Contents
Advertisement
Chapter 3 - Setup and Installation
6
7
8
9
This completes the setup and cabling of this configuration.
76
Multi-Port Mirrored Single Host-Single Connection Configuration
Connect the Fibre Channel data cable(s).
a
Connect a cable from the host HBA FC port to the "H0" connector on the
right Host I/O card.
NexStor 4921F/4922F/4941F/4942F
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Host Server
Multi-Port Mirrored Single Host-Single Connection Cabling Diagram
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN. Connect a second
CAT 5e ethernet cable from the second RAID Controller to another network
connection.
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
Power on your system, refer to "Powering On the Storage System" on
page 102.
D1
D2
H0
H1
H0
TEST
NETWORK
ONLY
SERVICE
TEST
NETWORK
ONLY
SERVICE
FC HBA
H1
Advertisement
Table of Contents
