Table of Contents
Advertisement
Chapter 4 - Managing and Monitoring
One-Touch Annunciation Configuration Display
The One-Touch Annunciation configuration display feature is an easily accessible
press-to-touch display of the SES Controller card switches 1 through 3 settings,
the fan speed control setting, Host I/O card and Disk I/O card bus speed modes,
presence of Disk I/O cards, Host I/O cards, and RAID Controllers.
By pressing and holding the Alarm Reset button, the Drive Activity LEDs will all
be extinguished and the Drive Status LEDs will illuminate in unique combinations
to indicate the settings and conditions. Below is an illustration and a table that
describes the Drive Status LEDs and their meanings:
108
One-Touch Annunciation Configuration Display
SES Switch
SES Switch
AD0 Position
AD1 Position
Disk I/O Mode
Host I/O Mode
1Gb/2Gb
1Gb/2Gb
Rt Host I/O
Lt Host I/O
Card Present
Card Present
Slot 1
SES Switch AD0
LED On = Up Position
LED Off = Down Position
Slot 2
Host I/O Cards 1 Gb/2 Gb Mode
Disk I/O Cards 1 Gb/2 Gb Mode
LED On = 2Gb Mode
LED Off = 1Gb Mode
Slot 3
Right Host I/O Card Present
LED On = Present
LED Off = Missing
Note: Both Host I/O cards must be set to the same mode setting, otherwise the LED will indicate 1 Gb mode, this also applies to the Disk I/O cards.
SES Switch
Fan Control
AD2 Position
Enabled
Upper Disk I/O
Lower Disk I/O
Card Present
Card Present
Lower CNTRL
Upper CNTRL
Present
Present
Status LED Call-Outs
One-Touch Annunciation Configuration Display
Slot 4
SES Switch AD1
LED On = Up Position
LED Off = Down Position
Slot 5
Upper Disk I/O Card Present
LED On = 2Gb Mode
LED Off = 1Gb Mode
Slot 6
Left Host I/O Card Present
Lower Controller Present
LED On = Present
LED Off = Missing
Status LED Conditions
Press and Hold
to display settings
Slot 7
SES Switch AD2
Fan Control
LED On = Up Position
LED On = Auto Control Enabled
LED Off = Down Position
LED Off = Disabled
Slot 8
Lower Disk I/O Card Present
LED On = Present
LED On = Present
LED Off = Missing
LED Off = Missing
Slot 9
Upper Controller Present
LED On = Present
LED On = Present
LED Off = Missing
LED Off = Missing
RESET ALARM
Slot 10
Slot 11
Slot 12
Advertisement
Table of Contents
