Table of Contents
Advertisement
6
Connect the Fibre Channel data cable(s).
a
Connect a cable from the first host (Node A) first HBA FC port to the
"H0" connector on the left Host I/O card.
b
Connect another cable from a first host (Node A) second HBA FC port to
the "H0" connector on the right Host I/O card.
c
Connect a cable from the second host (Node B) first HBA FC port to the
"H1" connector on the left Host I/O card.
d
Connect another cable from a second host (Node B) second HBA FC
port to the "H1" connector on the right Host I/O card.
NexStor 4911F/4912F/4931F/4932F
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Host Server: Node A
Host Server: Node B
Stand-Alone Dual Port Dual Host Dual Connection Cabling Diagram
7
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN.
8
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
Chapter 3 - Setup and Installation
D1
D2
H0
FC HBA
FC HBA
FC HBA
FC HBA
Stand-Alone Dual Port Dual Host Dual Connection Configuration
H1
H0
H1
NETWORK
TEST
ONLY
SERVICE
71
Advertisement
Table of Contents
