NexStor 4900F Series User Manual page 82

Chapter 3 - Setup and Installation
6
7
8
9
This completes the setup and cabling of this configuration.
68
Stand-Alone Dual Port Dual Host Single Connection Configuration
Connect the Fibre Channel data cable(s).
a Connect a cable from the first host (Node A) HBA FC port to the "H1"
connector on the left Host I/O card.
b Connect a cable from the second host (Node B) HBA FC port to the "H0"
connector on the right Host I/O card.
NexStor 4911F/4912F/4921F/4932F
Connect to Ethernet Switch or Hub (LAN)
10/100 Base-T Cable (embedded StorView)
Host Server: Node A
Host Server: Node B
Stand-Alone Dual Port Dual Host Single Connection Cabling Diagram
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN.
If you wish to add additional enclosure(s), refer to "Disk Expansion –
Daisy-Chaining" on page 95, otherwise continue with the steps below. The
example depicts one extra enclosure being added, however, you may add
more enclosures up to the allowable limit of 96 drives.
Power on your system, refer to "Powering On the Storage System" on
page 102.
D1 D2 H0 H1 H0
NETWORK TEST
ONLY SERVICE
FC HBA
FC HBA
H1