Table of Contents
Advertisement
Chapter 4 - Managing and Monitoring
10 Verify the new firmware has successfully loaded, type <Control-E>.
11 Press the <Esc> key to return to the terminal utility main menu.
114
Updating SES Controller Card Firmware
NOTE:
Ensure that the protocol "Xmodem" is selected.
From the Xmodem send screen you can monitor the progress of the upload.
You can safely stop the transfer without affecting your existing firmware any
time during the transfer until it has been completed. The upload does not
overwrite the firmware during the upload process, it writes the new code
into unused EEPROM space until completed, then erases the flash and
re-programs the new firmware code to the EEPROM active region.
If you elect to stop an upload in progress, ensure that the stop (abort)
command was completed by typing <Control-X> at the cursor.
Xmodem Transfer Screen
Advertisement
Table of Contents
