Table of Contents
Advertisement
Chapter 6 - Maintenance
3
4
5
6
7
8
138
Replacing a DC Power Supply
Using your thumb and fore finger, squeeze the power supply release latch
while pulling the power supply from the enclosure.
Remove the replacement power supply from the shipping container and
inspect for obvious damage. Save the packaging material.
Install the new power supply by sliding it into its open bay and ensuring it
seats completely and the release latch resets.
Re-connect the DC power cable. Insert the power cable connector into the
DC power cable module. It secures when the connector's latches reset.
Turn the On/Off switch to the "On" position on the replacement power
supply.
NOTE:
The front bezel Power Supply Status LED will return to a normal
state (steady green).
Using the packaging material from the replacement power supply, repackage
and return the failed power supply per your RMA instructions.
Advertisement
Table of Contents
