Additional Mib Objects To View Copy Statistics; Obtaining A Value For Mib Objects - Dell Z9000 Configuration Manual

myfilename
copyServerAddress.10 a 172.16.1.56 copyUserName.10 s mylogin copyUserPassword.
10 s mypass

Additional MIB Objects to View Copy Statistics

Dell Networking provides more MIB objects to view copy statistics, as shown in the following table.
Table 52. Additional MIB Objects for Copying Configuration Files via SNMP
MIB Object
copyState
copyTimeStarted
copyTimeCompleted
copyFailCause
copyEntryRowStatus

Obtaining a Value for MIB Objects

To obtain a value for any of the MIB objects, use the following command.
• Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
[OID.index | mib-object.index]
Simple Network Management Protocol (SNMP)
OID
.
1.3.6.1.4.1.6027.3.5.1.1.1.
1.11
.
1.3.6.1.4.1.6027.3.5.1.1.1.
1.12
.
1.3.6.1.4.1.6027.3.5.1.1.1.
1.13
.
1.3.6.1.4.1.6027.3.5.1.1.1.
1.14
.
1.3.6.1.4.1.6027.3.5.1.1.1.
1.15
Values
1= running
2 = successful
3 = failed
Time value
Time value
1 = bad filename
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Row status
Description
Specifies the state of the
copy operation.
Specifies the point in the
up-time clock that the
copy operation started.
Specifies the point in the
up-time clock that the
copy operation
completed.
Specifies the reason the
copy request failed.
Specifies the state of the
copy operation. Uses
CreateAndGo when you
are performing the copy.
The state is set to active
when the copy is
completed.
795