Dell Z9000 Configuration Manual page 415

eljefe.02-00 * 0x00000001
Force10.00-00 0x00000002
IS-IS Level-2 Link State Database
LSPID LSP Seq Num
B233.00-00 0x00000006
eljefe.00-00 * 0x0000000D
eljefe.01-00 * 0x00000001
eljefe.02-00 * 0x00000001
Force10.00-00 0x00000004
Dell#
Controlling Routing Updates
To control the source of IS-IS route information, use the following command.
• Disable a specific interface from sending or receiving IS-IS routing information.
ROUTER ISIS mode
passive-interface interface
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix
lists or Dell Networking OS does not install the route in the routing table. The prefix lists are globally
applied on all interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration
information on prefix lists, refer to
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
• Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name in [interface]
Enter the type of interface and slot/port information:
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
Intermediate System to Intermediate System
0x2E7F 1113
0xD1A7 1102
LSP Checksum LSP Holdtime ATT/P/OL
0xC38A 1124
0x51C6 1129
0x68DF 1122
0x2E7F 1113
0xCDA9 1107
Access Control Lists (ACLs).
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0
415