Sflow Show Commands; Displaying Show Sflow Global - Dell Z9000 Configuration Manual

Example of the show sflow command when the sflow max-header-size extended is configured
globally
Dell(conf-if-te-1/10)#show sflow
sFlow services are enabled
Egress Management Interface sFlow services are disabled
Global default sampling rate: 32768
Global default counter polling interval: 86400
Global default extended maximum header size: 256 bytes
Global extended information enabled: none
1 collectors configured
Collector IP addr: 100.1.1.12, Agent IP addr: 100.1.1.1, UDP port: 6343 VRF:
Default
0 UDP packets exported
0 UDP packets dropped
0 sFlow samples collected
Example of viewing the sflow max-header-size extended on an Interface Mode
Dell#show sflow interface tengigabitethernet 1/1
Te 1/1
sFlow type
Configured sampling rate
Actual sampling rate
Counter polling interval
Extended max header size
Samples rcvd from h/w
Example of the show running-config sflow Command
Dell#show running-config sflow
!
sflow collector 100.1.1.12 agent-addr 100.1.1.1
sflow enable
sflow max-header-size extended
Dell#show run int tengigabitEthernet 1/10
!
interface TenGigabitEthernet 1/10
no ip address
switchport
sflow ingress-enable
sflow max-header-size extended
no shutdown

sFlow Show Commands

Dell Networking OS includes the following sFlow display commands.
• Displaying Show sFlow Globally
• Displaying Show sFlow on an Interface
• Displaying Show sFlow on a Line Card

Displaying Show sFlow Global

To view sFlow statistics, use the following command.
• Display sFlow configuration information and statistics.
774
:Ingress
:16384
:16384
:20
:256
:0
sFlow