Dell Z9000 Configuration Manual page 352

duplex {half | full}
7. Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8. Verify configuration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE: The show interfaces status command displays link status, but not administrative
status. For both link and administrative status, use the show ip interface [interface |
brief | linecard slot-number] [configuration] command.
Dell#show interfaces status
Port Description Status Speed
Te 1/1 Down
Te 1/2 Down
Te 1/3 Down
Te 1/4 Force10Port Up
Te 1/5 Down
Te 1/6 Down
Te 1/7 Up
Te 1/8 Down
Te 1/9 Down
Te 1/10 Down
Te 1/11 Down
Te 1/12 Down
[output omitted]
In the previous example, several ports display "Auto" in the Speed field. In the following example, the
speed of port 1/1 is set to 100Mb and then its auto-negotiation is disabled.
Dell#configure
Dell(config)#interface tengig 1/1
Dell(conf-if-te-1/1)#speed 100
Dell(conf-if-te-1/1)#duplex full
Dell(conf-if-te-1/1)#no negotiation auto
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
speed 100
duplex full
no shutdown
352
Duplex Vlan
1000 Mbit Auto
Auto Auto
Auto Auto
1000 Mbit Auto
Auto Auto
Auto Auto
1000 Mbit Auto
Auto Auto
Auto Auto
Auto Auto
Auto Auto
Auto Auto
1
1
--
30-130
--
--
1502,1504,1506-1508,1602
--
--
--
--
--
Interfaces