Assigning An Ip Address To A Port Channel; Deleting Or Disabling A Port Channel; Load Balancing Through Port Channels; Load-Balancing Method - Dell Z9000 Configuration Manual

Dell#

Assigning an IP Address to a Port Channel

You can assign an IP address to a port channel and use port channels in Layer 3 routing protocols.
To assign an IP address, use the following command.
• Configure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
– ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in
slash format (/24).
– secondary: the IP address is the interface's backup IP address. You can configure up to eight
secondary IP addresses.

Deleting or Disabling a Port Channel

To delete or disable a port channel, use the following commands.
• Delete a port channel.
CONFIGURATION mode
no interface portchannel channel-number
• Disable a port channel.
shutdown
When you disable a port channel, all interfaces within the port channel are operationally down also.

Load Balancing Through Port Channels

Dell Networking OS uses hash algorithms for distributing traffic evenly over channel members in a port
channel (LAG).
The hash algorithm distributes traffic among Equal Cost Multi-path (ECMP) paths and LAG members. The
distribution is based on a flow, except for packet-based hashing. A flow is identified by the hash and is
assigned to one link. In packet-based hashing, a single flow can be distributed on the LAG and uses one
link.
Packet based hashing is used to load balance traffic across a port-channel based on the IP Identifier field
within the packet. Load balancing uses source and destination packet information to get the greatest
advantage of resources by distributing traffic over multiple paths when transferring data to a destination.
Dell Networking OS allows you to modify the hashing algorithms used for flows and for fragments. The
load-balance and hash-algorithm commands are available for modifying the distribution algorithms.
NOTE: Hash-based load-balancing on multi-protocol label switching (MPLS) does not work when
you enable packet-based hashing (load-balance ip-selection packet-based).

Load-Balancing Method

For LAG hashing on the source IP, destination IP, source transmission control protocol (TCP)/user
datagram protocol (UDP) port, and destination TCP/UDP port are used for hash computation by default.
Interfaces
333