Applying A Privilege Level To A Username; Applying A Privilege Level To A Terminal Line; Configuring Logging - Dell Z9000 Configuration Manual

vlan
Dell(conf)#interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)#?
end
exit
Dell(conf-if-te-1/1)#exit
Dell(conf)#line ?
aux
console
vty
Dell(conf)#line vty 0
Dell(config-line-vty)#?
exit
Dell(config-line-vty)#
Dell(conf)#interface group ?
fortyGigE
gigabitethernet
tengigabitethernet
vlan
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/1
Dell(conf-if-group-vl-1-2,te-1/1)# no shutdown
Dell(conf-if-group-vl-1-2,te-1/1)# end

Applying a Privilege Level to a Username

To set the user privilege level, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level

Applying a Privilege Level to a Terminal Line

To set a privilege level for a terminal line, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE: When you assign a privilege level between 2 and 15, access to the system begins at EXEC
mode, but the prompt is hostname#, rather than hostname>.

Configuring Logging

The Dell Networking OS tracks changes in the system using event and error messages.
By default, Dell Networking OS logs these messages on:
• the internal buffer
• console and terminal lines
• any configured syslog servers
To disable logging, use the following commands.
• Disable all logging except on the console.
CONFIGURATION mode
60
VLAN interface
Exit from configuration mode
Exit from interface configuration mode
Auxiliary line
Primary terminal line
Virtual terminal
Exit from line configuration mode
FortyGigabit Ethernet interface
GigabitEthernet interface IEEE 802.3z
TenGigabit Ethernet interface
VLAN keyword
Management