Dell Z9000 Configuration Manual page 916

• For VRRPv3, change the advertisement centisecs interval setting.
INTERFACE-VRID mode
advertise-interval centisecs centisecs
The range is from 25 to 4075 centisecs in units of 25 centisecs.
The default is 100 centisecs.
Examples of the advertise-interval Command
The following example shows how to change the advertise interval using the advertise-interval
command.
Dell(conf-if-te-1/1)#vrrp-group 111
Dell(conf-if-te-1/1-vrid-111)#advertise-interval 10
Dell(conf-if-te-1/1-vrid-111)#
The following example shows how to verify the advertise interval change using the show conf
command.
Dell(conf-if-te-1/1-vrid-111)#show conf
!
vrrp-group 111
advertise-interval 10
authentication-type simple 7 387a7f2df5969da4
no preempt
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
Track an Interface or Object
You can set Dell Networking OS to monitor the state of any interface according to the virtual group.
Each VRRP group can track up to 12 interfaces and up to 20 additional objects, which may affect the
priority of the VRRP group. If the tracked interface goes down, the VRRP group's priority decreases by a
default value of 10 (also known as cost). If the tracked interface's state goes up, the VRRP group's priority
increases by 10.
The lowered priority of the VRRP group may trigger an election. As the Master/Backup VRRP routers are
selected based on the VRRP group's priority, tracking features ensure that the best VRRP router is the
Master for that group. The sum of all the costs of all the tracked interfaces must be less than the
configured priority on the VRRP group. If the VRRP group is configured as Owner router (priority 255),
tracking for that group is disabled, irrespective of the state of the tracked interfaces. The priority of the
owner group always remains at 255.
For a virtual group, you can track the line-protocol state or the routing status of any of the following
interfaces with the interface interface parameter:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
916
Virtual Router Redundancy Protocol (VRRP)