Dell Z9000 Configuration Manual page 86

dot1x authentication
2. Enter INTERFACE mode on an interface or a range of interfaces.
INTERFACE mode
interface [range]
3. Enable 802.1X on the supplicant interface only.
INTERFACE mode
dot1x authentication
Examples of Verifying that 802.1X is Enabled Globally and on an Interface
Verify that 802.1X is enabled globally and at the interface level using the show running-config |
find dot1x command from EXEC Privilege mode.
In the following example, the bold lines show that 802.1X is enabled.
Dell#show running-config | find dot1x
dot1x authentication
!
[output omitted]
!
interface TenGigabitEthernet 2/1
no ip address
dot1x authentication
no shutdown
!
Dell#
To view 802.1X configuration information for an interface, use the show dot1x interface command.
In the following example, the bold lines show that 802.1X is enabled on all ports unauthorized by default.
Dell#show dot1x interface TenGigabitEthernet 2/1/
802.1x information on Te 2/1/:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:
86
Enable
AUTO
UNAUTHORIZED
Disable
None
Disable
NONE
Disable
NONE
Disable
Disable
30 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Initialize
Initialize
802.1X