Dynamic Counters; Clearing Interface Counters - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput

Hide thumbs Also See for Z9000:

Table of Contents

Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Time since last interface status change: 1d23h42m

Dynamic Counters

By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.

For the remaining applications, Dell Networking OS automatically turns on counting when you enable the

application, and is turned off when you disable the application.

NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an

impact on line rate performance.

The following counter-dependent applications are supported by Dell Networking OS:

Ingress VLAN

The counters in the show interfaces command are reset by the clear counters command. This

command does not clear the counters any SNMP program captures.

To clear the counters, use the following the command.

Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical

interfaces or selected ones. Without an interface specified, the command clears all interface counters.

EXEC Privilege mode

clear counters [interface] [vrrp [vrid] | learning-limit]

(OPTIONAL) Enter the following interface keywords and slot/port or number information:

– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port

information.

– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then

the slot/port information. The slot range is from 0 to 1. The port range is 0.

– For a port channel interface, enter the keywords port-channel then a number.

– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a

number from 1 to 255 as the vrid.