Interworking Of Eis With Various Applications - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput

Hide thumbs Also See for Z9000:

Table of Contents

Default Behavior: Route lookup is done in the default routing table and appropriate egress port is

Snmp (snmp mib response)

icmp (ping and traceroute)

Interworking of EIS With Various Applications

The management EIS is enabled on the master and the standby unit.

Because traffic can be initiated from the Master unit only, the preference to management EIS table for

switch-initiated traffic and all its related ARP processing is done in the Master unit only.

ARP-related processing for switch-destined traffic is done by both master and standby units.

VLT feature is for the front-end port only. Because this feature is specific to the management port, this

feature can coexist with VLT and nothing specific needs to be done in this feature to handle VLT scenario.

If DHCP Client is enabled on the management port, a management default route is installed to the

If management EIS is enabled, this default route is added to the management EIS routing table and the

default routing table.

ARP learn enable

When ARP learn enable is enabled, the switch learns ARP entries for ARP Request packets even if the

packet is not destined to an IP configured in the box.

The ARP learn enable feature is not applicable to the EIS routing table. It is applicable to the default

routing table only to avoid unnecessary double ARP entries

sFlow management application is supported only in standalone boxes and switch shall throw error

message if sFlow is configured in stacking environment

Behavior when EIS is Enabled

EIS Behavior

EIS Behavior for ICMP

Behavior when EIS is Disabled

Default Behavior

Internet Group Management Protocol (IGMP)