Ospf Area 0 - Te 3/1 And 3/2; Ospf Area 0 - Te 2/1 And 2/2; Configuration Task List For Ospfv3 (Ospf For Ipv6) - Dell Z9000 Configuration Manual

no shutdown
!
interface Loopback 10
ip address 192.168.100.100/24
no shutdown
OSPF Area 0 — Te 3/1 and 3/2
router ospf 33333
network 192.168.100.0/24 area 0
network 10.0.13.0/24 area 0
network 10.0.23.0/24 area 0
!
interface Loopback 30
ip address 192.168.100.100/24
no shutdown
!
interface TenGigabitEthernet 3/1
ip address 10.1.13.3/24
no shutdown
!
interface TenGigabitEthernet 3/2
ip address 10.2.13.3/24
no shutdown
OSPF Area 0 — Te 2/1 and 2/2
router ospf 22222
network 192.168.100.0/24 area 0
network 10.2.21.0/24 area 0
network 10.2.22.0/24 area 0
!
interface Loopback 20
ip address 192.168.100.20/24
no shutdown
!
interface TenGigabitEthernet 2/1
ip address 10.2.21.2/24
no shutdown
!
interface TenGigabitEthernet 2/2
ip address 10.2.22.2/24
no shutdown

Configuration Task List for OSPFv3 (OSPF for IPv6)

The configuration options of OSPFv3 are the same as those options for OSPFv2, but you may configure
OSPFv3 with differently labeled commands. Specify process IDs and areas and include interfaces and
addresses in the process. Define areas as stub or totally stubby.
The interfaces must be in IPv6 Layer-3 mode (assigned an IPv6 IP address) and enabled so that they can
send and receive traffic. The OSPF process must know about these interfaces. To make the OSPF process
aware of these interfaces, assign them to OSPF areas.
The OSPFv3 ipv6 ospf area command enables OSPFv3 on the interface and places the interface in an
area. With OSPFv2, two commands are required to accomplish the same tasks — the router ospf
Open Shortest Path First (OSPFv2 and OSPFv3)
577