Adding And Removing Interfaces - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput
Hide thumbs Also See for Z9000:
Table of Contents

Advertisement

BPDU : sent 121, received 2
The port is not in the Edge port mode
Port 379 (TenGigabitEthernet 2/3) is designated Forwarding
Port path cost 20000, Port priority 128, Port Identifier 128.379
Designated root has priority 32768, address 0001.e801.cbb4
Designated bridge has priority 32768, address 0001.e801.cbb4
Designated port id is 128.379, designated path cost 0
Number of transitions to forwarding state 1
BPDU : sent 121, received 5
The port is not in the Edge port mode
Port 380 (TenGigabitEthernet 2/4) is designated Forwarding
Port path cost 20000, Port priority 128, Port Identifier 128.380
Designated root has priority 32768, address 0001.e801.cbb4
Designated bridge has priority 32768, address 0001.e801.cbb4
Designated port id is 128.380, designated path cost 0
Number of transitions to forwarding state 1
BPDU : sent 147, received 3
The port is not in the Edge port mode
To confirm that a port is participating in RSTP, use the show spanning-tree rstp brief command
from EXEC privilege mode.
R3#show spanning-tree rstp brief
Executing IEEE compatible Spanning Tree Protocol
Root ID Priority 32768, Address 0001.e801.cbb4
Root Bridge hello time 2, max age 20, forward delay 15
Bridge ID Priority 32768, Address 0001.e80f.1dad
Configured hello time 2, max age 20, forward delay 15
Interface
Name
PortID
Prio Cost
---------- -------- ----
Te 3/1
128.681 128
Te 3/2
128.682 128
Te 3/3
128.683 128
Te 3/4
128.684 128
Interface
Name
Role
PortID
------- --- ------ -------- ---- ------- --- -----------
Te 3/1
Altr
128.681 128 20000
Te 3/2
Altr
128.682 128 20000
Te 3/3
Root
128.683 128 20000
Te 3/4
Altr
128.684 128 20000
R3#

Adding and Removing Interfaces

To add and remove interfaces, use the following commands.
To add an interface to the Rapid Spanning Tree topology, configure it for Layer 2 and it is automatically
added. If you previously disabled RSTP on the interface using the command no spanning-tree 0
command, re-enable it using the spanning-tree 0 command.
Remove an interface from the Rapid Spanning Tree topology.
no spanning-tree 0
706
Designated
Sts Cost
Bridge ID
------- --- ------- ------------- --------
20000
BLK 20000 32768 0001.e80b.88bd
20000
BLK 20000 32768 0001.e80b.88bd
20000
FWD 20000 32768 0001.e801.cbb4
20000
BLK 20000 32768 0001.e801.cbb4
Prio Cost
Sts Cost
BLK 20000
BLK 20000
FWD 20000
BLK 20000
PortID
128.469
128.470
128.379
128.380
Link-type Edge
P2P
No
P2P
No
P2P
No
P2P
No
Rapid Spanning Tree Protocol (RSTP)

Advertisement

Table of Contents
loading

Table of Contents