Storm Control; Configure Storm Control; Configuring Storm Control From Interface Mode; Configuring Storm Control From Configuration Mode - Dell Z9000 Configuration Manual

Storm Control

Storm control is supported on Dell Networking OS.
The storm control feature allows you to control unknown-unicast and broadcast traffic on Layer 2 and
Layer 3 physical interfaces.
Dell Networking Operating System (OS) Behavior: Dell Networking OS supports broadcast control (the
storm-control broadcast command) for Layer 2 and Layer 3 traffic.

Configure Storm Control

Storm control is supported in INTERFACE mode and CONFIGURATION mode.

Configuring Storm Control from INTERFACE Mode

To configure storm control, use the following command.
From INTERFACE mode:
• You can only on configure storm control for ingress traffic.
• If you configure storm control from both INTERFACE and CONFIGURATION mode, the INTERFACE
mode configurations override the CONFIGURATION mode configurations.
• The percentage of storm control is calculated based on the advertised rate of the line card, not by the
speed setting.
• Configure storm control.
INTERFACE mode
storm control

Configuring Storm Control from CONFIGURATION Mode

To configure storm control from CONFIGURATION mode, use the following command.
From CONFIGURATION mode you can configure storm control for ingress and egress traffic.
Do not apply per-viritual local area network (VLAN) quality of service (QoS) on an interface that has
storm-control enabled (either on an interface or globally).
• Configure storm control.
CONFIGURATION mode
storm control
806
47
Storm Control