Monitoring Fips Mode Status; Disabling Fips Mode - Dell Z9000 Configuration Manual

Monitoring FIPS Mode Status

To view the status of the current FIPS mode (enabled/disabled), use the following commands.
• Use either command to view the status of the current FIPS mode.
show fips status
show system
Examples of the show fips status and show system Commands
The following example shows the show fips status command.
Dell#show fips status
FIPS Mode : Enabled
for the system using the show system command.
The following example shows the show system command.
Dell#show system
Stack MAC : 00:01:e8:8a:ff:0c
Reload Type : normal-reload [Next boot : normal-reload]
-- Unit 0 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S4810 - 52-port GE/TE/FG (SE)
Current Type : S4810 - 52-port GE/TE/FG (SE)
Master priority : 0
Hardware Rev : 3.0
Num Ports : 64
Up Time : 7 hr, 3 min
Dell Networking OS Version
Jumbo Capable : yes
POE Capable : no
FIPS Mode : enabled
Burned In MAC : 00:01:e8:8a:ff:0c
No Of MACs : 3
...

Disabling FIPS Mode

The following describes disabling FIPS mode.
When you disable FIPS mode, the following changes occur:
• The SSH server disables.
• All open SSH and Telnet sessions, as well as all SCP and FTP file transfers, close.
• Any existing host keys (both RSA and RSA1) are deleted from system memory and NVRAM storage.
• FIPS mode disables.
• The SSH server re-enables.
• The Telnet server re-enables (if it is present in the configuration).
276
: 4810-8-3-7-1061
Enabling FIPS Cryptography