Undoing Commands - Dell Z9000 Configuration Manual

----
0 Management
1 Member
2 Member
3 Member
4 Member
5 Member
6 Member
7 Member
8 Member
9 Member
10 Member
11 Member
-- Power Supplies
Unit Bay Status
---------------------------------------------------------------------------
0 0 absent
0 1 up
-- Fan Status --
Unit Bay TrayStatus
--------------------------------------------------------------------------------
----
0 0 up
0 1 up
Speed in RPM
Dell(conf)#

Undoing Commands

When you enter a command, the command line is added to the running configuration file (running-
config).
To disable a command and remove it from the running-config, enter the no command, then the original
command. For example, to delete an IP address configured on an interface, use the no ip address
ip-address command.
NOTE: Use the help or ? command as described in
Example of Viewing Disabled Commands
Dell(conf)#interface tengigabitethernet 4/17
Dell(conf-if-te-4/17)#ip address 192.168.10.1/24
Dell(conf-if-te-4/17)#show config
!
interface TenGigabitEthernet 4/17
ip address 192.168.10.1/24
no shutdown
Dell(conf-if-te-4/17)#no ip address
Dell(conf-if-te-4/17)#show config
!
interface TenGigabitEthernet 4/17
no ip address
no shutdown
38
online S4810
not present
not present
not present
not present
not present
not present
not present
not present
not present
not present
not present
--
Type FanStatus
absent
UNKNOWN up
Fan0 Speed
up 9120
up 9120
S4810
Fan1 Speed
up 9120
up 9120
Obtaining Help.
9.4(0.0) 64
Configuration Fundamentals