Dell Z9000 Configuration Manual page 640

The following examples show the results of using this command without the command options on
the C300 and S50V switches in the topology diagram previously shown.
• Display the primary-secondary VLAN mapping. The following example shows the output from the
S50V.
show vlan private-vlan mapping
This command is specific to the PVLAN feature.
Examples of Viewing a Private VLAN using the show Commands
The show arp and show vlan commands are revised to display PVLAN data.
The following example shows viewing a private VLAN.
c300-1#show vlan private-vlan
Primary Secondary Type
------- --------- --------- ------ --------------
4000
4001
4002
4003
The following example shows using the show vlan private-vlan mapping command.
S50-1#show vlan private-vlan mapping
Private Vlan:
Primary : 4000
Isolated : 4003
Community : 4001
NOTE: In the following example, notice the addition of the PVLAN codes – P, I, and C – in the left
column.
The following example shows viewing the VLAN status.
S50V#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I -
Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description
* 1 Inactive
100 Inactive
P 200 Inactive primary VLAN in PVLAN
I 201 Inactive isolated VLAN in VLAN 200 T Te 1/21
The following example shows viewing a private VLAN configuration.
!
interface TenGigabitEthernet 1/3
no ip address
switchport
switchport mode private-vlan promiscuous
no shutdown
!
interface TenGigabitEthernet 1/4
no ip address
switchport
switchport mode private-vlan host
no shutdown
640
Active Ports
Primary Yes
Community Yes
Community Yes
Isolated Yes
Te 1/1,23,25
Te 4/1,23
Te 4/24,47
Te 1/24,47
Q Ports
T Te 1/19-20
Private VLANs (PVLAN)