Dell Z9000 Configuration Manual page 231

CAM Allocation
vrfv4Acl
Openflow
fedgovacl
The following additional CAM allocation settings are supported on the S6000, S4810, S4820T, or S6000–
ON platforms.
Table 11. Additional Default CAM Allocation Settings
Additional CAM Allocation
FCoE ACL (fcoeacl)
ISCSI Opt ACL (iscsioptacl)
The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other
profile allocations can use either even or odd numbered ranges.
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
CAM Allocation for Ingress
Use the cam-acl-egress command to allocate the space for egress L2, IPV4 and IPV6 ACL. The total
number of available FP blocks is 4. Allocate atleast one group of L2ACL and IPV4 ACL.
Dell(conf)#do show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 7 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Dell(conf)#
1. Select a cam-acl action.
CONFIGURATION mode
cam-acl [default | l2acl]
Content Addressable Memory (CAM)
1 block = 256 entries
1
1
2
1
1
2
1
1
2
Setting
0
0
0
Setting
0
0
231