Dell Z9000 Configuration Manual page 929

S2(conf-if-vl-300-vrid-101)#virtual-address 20.1.1.5
S2(conf-if-vl-300)#no shutdown
Dell#show vrrp vrf vrf1 vlan 400
------------------
Vlan 400, IPv4 VRID: 1, Version: 2, Net: 10.1.1.1
VRF: 1 vrf1
State: Master, Priority: 100, Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 278, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.100
Authentication: (none)
Vlan 400, IPv4 VRID: 10, Version: 2, Net: 20.1.1.2
VRF: 1 vrf1
State: Backup, Priority: 90, Master: 20.1.1.1
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 377, Bad pkts rcvd: 0, Adv sent: 0, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
20.1.1.100
Authentication: (none)
Dell#show vrrp vrf vrf2 port-channel 1
------------------
Port-channel 1, IPv4 VRID: 1, Version: 2, Net: 10.1.1.1
VRF: 2 vrf2
State: Master, Priority: 100, Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 419, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.100
Authentication: (none)
Displaying VRRP in a VRF Configuration
To display information on a VRRP group that is configured on an interface that belongs to a VRF instance,
use the following commands.
• Display information on a VRRP group that is configured on an interface that belongs to a VRF
instance.
show running-config track [interface interface]
• Display information on VRRP groups configured on interfaces that belong to a VRF instance.
show vrrp vrf [vrf instance]
Examples of Verifying the Configuration and Status on the VRRP in a VRF
The following example shows viewing the configuration of VRRP in a VRF (interface).
Dell#show running-config track interface tengigabitethernet 1/4
interface TenGigabitEthernet 1/4
ip vrf forwarding red
ip address 192.168.0.1/24
vrrp-group 4
Virtual Router Redundancy Protocol (VRRP)
929