Configuration Information; Configuration Task List For Ospfv2 (Ospf For Ipv4) - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput
Hide thumbs Also See for Z9000:
Table of Contents

Advertisement

Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 1.1.1.1 (Backup Designated Router)
Dell (conf-if-te-2/2)#

Configuration Information

The interfaces must be in Layer-3 mode (assigned an IP address) and enabled so that they can send and
receive traffic. The OSPF process must know about these interfaces.
To make the OSPF process aware of these interfaces, they must be assigned to OSPF areas.
You must configure OSPF GLOBALLY on the system in CONFIGURATION mode.
NOTE: Loop back routes are not installed in the Route Table Manager (RTM) as non-active routes.
OSPF features and functions are assigned to each router using the CONFIG-INTERFACE commands for
each interface.
NOTE: By default, OSPF is disabled.

Configuration Task List for OSPFv2 (OSPF for IPv4)

The following configuration tasks include two mandatory tasks and several optional tasks:
Enabling OSPFv2
(mandatory)
Assigning a Router ID
Enabling Multi-Process OSPF
Assigning an OSPFv2 Area
Enable OSPFv2 on Interfaces
Configuring Stub Areas
Enabling Passive Interfaces
Enabling Fast-Convergence
Changing OSPFv2 Parameters on Interfaces
Enabling OSPFv2 Authentication
Creating Filter Routes
Applying Prefix Lists
Redistributing Routes
Troubleshooting OSPFv2
1.
Configure a physical interface. Assign an IP address, physical or Loopback, to the interface to enable
Layer 3 routing.
2.
Enable OSPF globally. Assign network area and neighbors.
3.
Add interfaces or configure other attributes.
For a complete list of the OSPF commands, refer to the OSPF section in the Dell Networking OS
Command Line Reference Guide document.
Enabling OSPFv2
To enable Layer 3 routing, assign an IP address to an interface (physical or Loopback). By default, OSPF,
similar to all routing protocols, is disabled.
You must configure at least one interface for Layer 3 before enabling OSPFv2 globally.
Open Shortest Path First (OSPFv2 and OSPFv3)
(mandatory)
561

Advertisement

Table of Contents
loading

Table of Contents