Kikusui PLZ164W User Manual page 67

PLZ-4W
4. Select the voltage range.
Press the VRANGE (SHIFT+RANGE) key.
A voltage range pop-up menu appears.
Each time you press the VRANGE key, the voltage range switches
between 15 V and 150 V.
When the desired range is highlighted, stop pressing the key.
5. Set the current value.
Check that the display is in the basic setting entry condition (the characters
"SET" is highlighted).
While viewing the display, turn the rotary knob.
First, use coarse adjustment to roughly set the value, and then switch to fine
adjustment to adjust the value precisely.
6.
Turn on the load.
Press the LOAD key.
The LOAD LED illuminates, and the current flows.
The display shows the measured values (voltage, current, and wattage)
at the load input terminal.
7. Change the current setting.
Turn the rotary knob to change the current setting.
The current value cannot be set greater than the maximum value of the selected
range.
8. Turn off the load.
Press the LOAD key.
The LOAD LED turns off, and the current is cut off.
■ Operating procedure of CC+CV mode
MODE SET / VSET
LOAD
+ CV
MENU
SW ON FREQ / DUTY
Th/TL
SWITCHING
Fig. 5-4 Keys used in CC+CV mode
1. Check the operation mode.
Check that CC is indicated on the display.
2. Select the operation mode.
Press the +CV (SHIFT+MODE) key.
The mode switches to CC+CV.
Check that CC+CV is indicated on the display.
LOAD
RANGE SLEW RATE OPP / OCP RECALL
VRANGE SHORT UVP STORE
LEVEL A B C
EDIT RUN / STOP PAUSE
I
PRESET SEQ
LOCK
ENTER
ABC
SHIFT
Basic Operation 5-11