Kikusui PLZ164W User Manual page 49

[1] DC INPUT (load input terminal on the rear panel)
[2] Air outlet
[3] AC INPUT connector
[4] Remote sensing terminal
[5] Manufacturing number (serial No.)
[6] GPIB connector
[7] RS232C connector
[8] USB connector
[9] J1/J2 connector
[10] EXT CONT
PLZ-4W
Terminal used to connect the equipment under test to the PLZ-4W. It is connected in
parallel with the load input terminal on the front panel.
• For the connection procedure, see section 2.8.2, "Connection to the Load Input
Terminal on the Rear Panel."
Exhausts the internal air using the cooling fan to cool the inside of the PLZ-4W.
Connector used to connect the power cord.
• For a description of the connection, see section 2.4, "Connecting the Power
Cord."
Terminal used to connect the sensing wires when correcting the voltage drop caused
by the resistance of the load wire.
• For details, see section 6.7, "Remote Sensing Function."
Manufacturing number of the PLZ-4W.
Connector used to connect the GPIB cable when controlling the PLZ-4W externally.
• For a description of the interface setup, see section 7.2.1, "GPIB Control."
Connector used to connect the RS232C cable when controlling the PLZ-4W exter-
nally.
• For a description of the interface setup, see section 7.2.2, "RS232C Control."
Connector used to connect the USB cable when controlling the PLZ-4W externally.
• For a description of the interface setup, see section 7.2.3, "USB Control."
Input/Output connector used to control the PLZ-4W externally using external volt-
age, resistance, relay contact, etc.
J1 is assigned to external control; J2 is assigned to parallel operation.
• For details on external control and the connector, see section 6.8.1, "Overview
and Precaution of External Control."
Variable resistor used to adjust the full scale and offset settings of the PLZ-4W with
respect to the input value of the external control source (voltage or resistance).
Names and Functions of Parts 4-5