Kikusui PLZ164W User Manual page 47

[1] DC INPUT (load input terminal on the front panel)
NOTE
[2] Air intake (louver)
[3] Handle
[4] POWER switch
[5] I MON OUT connector
[6] TRIG OUT connector
[7] REMOTE connector
PLZ-4W
The terminal on the front panel that can be used to easily connect the equipment
under test and the PLZ-4W. The load input terminal is also available on the rear
panel, and is connected in parallel with the load input terminal on the front panel.
• For the connection procedure, see section 2.8.3, "Connection to the Load Input
Terminal on the Front Panel."
• The specifications of the PLZ-4W are for the load input terminal on the rear panel.
The load input terminal on the front panel may not satisfy the specifications.
• The maximum input current to the load input terminal on the front panel is 66 A.
It is automatically limited to 66 A.
Takes in air to cool the inside of the PLZ-4W.
A dust filter is furnished on the inside. Clean the dust filter periodically.
• For details, see section 8.1.2, "Cleaning the Dust Filter."
Used to lift the PLZ-4W. The handle is provided on the side panel on the
PLZ1004W and the PLZ664WA. It is provided on the top panel on other models.
Power switch of the PLZ-4W. Push ( ) to turn on, push ( ) to turn off.
Turn the POWER switch on while holding down the ENTER key initializes the
panel settings to factory default.
• For a description of turning on the power, see section 2.6, "Turning on The
Power."
• For a description of initial settings, see section 5.14, "Initialization."
Output connector used to monitor the current. Connect a voltmeter or oscilloscope
to monitor the current.
• For details, see section 6.9, "Monitor Signal Output."
Outputs pulse signals during sequence operation or switching operation.
• For details, see section 6.9, "Monitor Signal Output."
Connector for future functional expansion.
Names and Functions of Parts 4-3