Kikusui PLZ164W User Manual page 114

6-28 Applied Operation
A program is a collection of steps (execution unit). When program 11 is executed
(RUN), steps are executed one by one in ascending order from step number 0001.
The completion of the last step signifies the end of one program execution.
• Step
Current Current for the step
STEP Step number
T Specify the step when you wish to output a trigger signal using T.
• TRIG (trigger output)
TRIG sets the presence or absence of
trigger output. When turned on, a trigger
signal is output from the TRIG OUT
connector on the front panel at the same
time as the step is executed.
• FILL function
This function automatically sets the current values of steps in between two sepa-
rated steps for which you specify the current values.
Steps 16 to 100
10.00 STEP:0014
A
FILL
DATA1: 0.164
A
DATA2: 1.164
A
START: 0016
STOP : 0100
ENTER
M1
Steps 101 to 200
10.00 STEP:0014
A
FILL
DATA1: 0.164
A
DATA2: 1.164
A
START: 0101
STOP :
0200
ENTER
M1
Fig. 6-18 Setup example using the FILL function
• DATA1 Current value at the start step (0.000 to 100 % of the range setting)
• DATA2 Current value at the end step (0.000 to 100 % of the range setting)
• START Start step number
• STOP End step number
In Fig. 6-18, the same waveform is repeated twice. DATA1 and DATA2 of the two
waveforms are set to the same values, respectively, for each two-point interval. The
values between two points are automatically assigned.
(Example) Set trigger output at step
Fig. 6-17
Current
value
1.164 A
(DATA2)
0.164 A
(DATA1)
Step
16 100 101
(START) (STOP) (START) (STOP)
number n (TRIG ON)
Step n
Step n-1
TRIG OUT
200
PLZ-4W