Kikusui PLZ164W User Manual page 111

SEQ
No. : 2
Memo : Pro g ram2
Mode : NCC
Ran g e : 33A, 150V
Loop : 0002
PREV NEXT
SEQ
Last Load : OFF
Last Set : 0.000
A
Chain : OFF
PREV NEXT
SEQ EDIT
CC SET [ A ]
001 10.000
A
002 5.000
A
003 8.000
A
END
TOTAL 003
PREV NEXT
SEQ EDIT
h : m i n : s . m s
[ ]
001 0:03 : 20––
002 0:00 : 5000
003 0:02 : 30––
END
TOTAL 003
PREV NEXT
SEQ EDIT
LOAD RAMP TRIG PAUSE
001 ON ON OFF OFF
002 ON OFF OFF OFF
003 ON ON OFF OFF
END
TOTAL 003
PREV
PLZ-4W
22. Select the operation mode, range, and the number of program loops.
Set the operation mode, range, and the number of program loops of program 2
in the same fashion as steps 4 to 6.
In program 2, set the operation mode to CC, the range to 33 A, 150 V
(PLZ164W), and the number of program loops to 2.
At the last line, move the
23. Set the load condition after the end of the program and the current
value.
Select the load condition and the current value after the end of program 2 (exe-
cuted twice) in the same fashion as steps 7 and 8.
Since the load is turned off and the current is set to 0 A after executing pro-
gram 2 twice, set OFF and 0 A, respectively.
After setting the load condition and the current value, move the
key to move to the next item.
24. Set the number of the program to be executed next.
Since the sequence operation is ended after executing program 2 twice, select
OFF.
Press the NEXT (SHIFT+
screen.
■ Setting the steps of program 2
25. Set the current values of step 1 to 3.
Repeat steps 10 to 13 to set the current value of step 1 (10 A), the current value
of step 2 (5 A), and the current value of step 3 (8 A).
After setting the current values, press the NEXT (SHIFT+
ENTER key to move to the next edit screen.
26. Set the execution times of step 1 to 3.
Repeat steps 14 to 16 to set the execution time of step 1 (200 s (03 min:20 s)),
the execution time of step 2 (50 s), and the execution time of step 3 (150 s (02
min:30 s)).
After setting the execution times, press the NEXT (SHIFT+
ENTER key to move to the next edit screen.
27. Set the execution patterns of step 1 to 3.
Repeat steps 17 and 18 to set the execution pattern of step 1 (LOAD ON,
RAMP ON, TRIG OFF, and PAUSE OFF), the execution pattern of step 2
(LOAD ON, RAMP OFF, TRIG OFF, and PAUSE OFF), and the execution
pattern of step 3 (LOAD ON, RAMP ON, TRIG OFF, and PAUSE OFF).
We are done entering all the settings of program 2.
28. Finish editing.
Pressing the PREV (SHIFT+
Since we wish to return to the screen before entering the sequence edit screen,
press the PREV (SHIFT+
played.
CURSOR key to move to the next item.
) key or ENTER key to move to the next edit
) returns to the previous page.
) key when the program edit (SEQ) screen is dis-
CURSOR
) key or the
) key or the
Applied Operation 6-25