Transmission - Konica Minolta BIZHUB 163 Service Manual

10. Fax Error
10.2.2

Transmission

Code
0080 Did not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081 Received DTC signal in transmission phase.
0082 Transmitting unit receives a signal other than DIS or DTC. and DCN in phase B.
0083 Detected FSK signal, but did not receive any signal within 35 seconds.
0084 Detect DCN signal in phase B.
Transmitting unit sending DCS 3 times consecutively, but each time receiver responds with
0085
DIS/DTC.
0086 Detected response signal other than DTC, DIS, FTT, DCN or CFR after sending DCS.
0087 Training attempt has failed because speed unit cannot adjust to low lower speed.
0088 Received DCN signal after sending out DCS signal.
0089 Remote side no mailbox function or not compatible.
008A Remote side not enough memory for relay initiate.
008B Receiver's protocol of DIS is received, but it is not compatible with our machine.
008C Remote side not enough memory for relay initiate.
Receiver's protocol of DIS is received, but remote side can't receive document temporary,
008D
may be run out of paper or other reason.
008E Remote side CSI number not defined in machine one touch or speed dial directory.
008F Modem not ready to receive V.34 data during 6 seconds after receiving CFR signal.
0090 Called side document not ready for our polling.
0091 Sending out DCS+TCF signal 3 times consecutively but no signal in response from receiver.
0092 Remote side disconnected during transmitting phase.
0093 Received DCN signal after sending out DCS signal for V.34.
0094 Time out during transmission of ECM frame or RCP command.
0095 Wrong ID number when Polling RX or Mail Box TX.
0099 Remote side disconnect after primary channel.
009A Did not detect any signal after sending CI signal.
009C Received DCN after sending DTC in V.34 polling RX.
009D Remote side hang up before V.34 modem enters phase B state in V.34 polling RX.
009F Did not receive any response from other side after sending PPS_EOM signal.
00A0 User stops or cancels transmission job.
00A1 Document JAM during transmission.
00AE Did not finish V.8 procedure or detect V.21 signal after CM signal within 30 seconds.
00AF Modem can not enter into control channel after TX side sends out RCP signal for V.34.
00B0 Did not receive any command after our side retry three DCS signal in V.34 TX.
00B1 Did not finish V.8 procedure or detect V.21 signal after ANSam signal within 35 seconds.
00B2 Did not detect phase B signal after our side sending CJ signal within 30 seconds.
00B3 Did not detect correct V.21 or JM signal after sending CM signal.
00B4 Did not detect correct phase B signal within 25 second after CM/JM signal exchange.
00B5 Did not detect phase C signal after phase B within 25 seconds.
00B6 Did not detect phase D signal within 25 seconds after CM/JM exchange.
00B7 Did not detect phase E signal after phase D within 30 seconds.
120
Field Service Ver. 1.0 Apr. 2007
Possible Causes of Error.