Konica Minolta BIZHUB 163 Service Manual page 315

8. Soft Switch Set
Switch
Bit No.
No.
8/7 Pause delay time within digit
# 30
6/5/4/3/2/1 Signal tone Insensitivity after dial for busy tone
# 31 – Reserved
# 32 – Reserved
7 V.17 echo protection tone
6 V.29 echo protection tone
# 33
5 Compromise equalize enable (CEQ) in the transmit path (TCEQ)
4 Compromise equalize enable (CEQ) in the receiver path (RCEQ)
# 34 – Reserved
8/7 Dial tone table switch time
# 35 6/5/4 Dial tone frequency upper range index
3/2/1 Dial tone frequency low range index
8 Re-dial attempts continue fall counter
# 36
4/3/2/1 Re-dial attempts fail limitation counter
8 Polling TX type for V.34 modem
7 Auto dial learning for V.34 modem
# 37
6/5/4 RX start symbol rate for V.34 modem
3/2/1 TX start symbol rate for V.34 modem
7 Set/ reset V.34 transmit level deviation
6/5 V.34 flag number between ECM frame
# 38
4 Phase 2 guard tone power level (V.34)
1 V.8/ V.34 capability
8 Disable V.34 TX for V.34 modem
7 Disable V.34 RX for V.34 modem
6/5 Flags number in FSK for V.34 modem
# 39
4 Manual TX mode for V.34 modem
3 Switch from V.17 to V.34 if DIS bit 6 set after received DIS
Delay time in primary channel for V.34 transmit after CFR or MCF
2/1
signal
8/7/6/5 V.17 RX start speed
# 40
3/2/1 V.34 RX start speed
8/7/6/5 V.17 TX start speed
# 41
3/2/1 V.34 TX start speed
# 42 – Reserved
# 43 – Reserved
# 44 – Reserved
6 Closed network
# 45 5 Call transfer
4/3/2/1 No. of call transfer
58
Field Service Ver. 1.0 Apr. 2007
Designation Page No.
P.83
P.84
P.84
P.85
P.85
P.86
P.87
P.88
P.89
P.89
P.90
P.91
P.92
P.92
P.92
P.93