Konica Minolta BIZHUB 163 Service Manual page 299

7. Service Mode
K. REPORT DESTINATION
Functions • Enter the telephone number for which the report is to be produced.
When any of the following conditions happens, the report is sent to the destination.
• Toner-empty condition
Use
• The IU Life Counter exceeds the specifications.
• The Maintenance Counter reaches a preset value.
Setting/ • Fax number specifications: An up-to-20-digit number that may consist of "0-9", " * ",
Procedure and "#". (0-9, #, *)
NOTE
• The report will be produced at a timing of 20 min., 24 hours, 48 hours, and 72
hours after any of the above conditions has occurred until the condition disap-
pears.
• If two or more conditions occur, only one report will be produced.
L. TONER EMPTY REPORT
Functions
• Select to generate a report to a specific destination when toner empty status occurs
in the engine.
Use
Setting/ • The default setting is "OFF".
Procedure
ON: Generate a report to report destination.
"OFF": Not to generate report.
M. IU LIFE REPORT
Functions
• Select to generate the report when IU LIFE COUNTER becomes out of life.
Use
Setting/ • The default setting is "OFF".
Procedure
ON: Generate a report to report destination.
"OFF": Not to generate report.
N. MAINTENANCE REPORT
Functions
• This function can be used to set whether or not to send the report when the mainte-
nance counter is zero.
Use
Setting/ • The default setting is "OFF".
Procedure
ON: Generate a report to report destination.
"OFF": Not to generate report.
42
Field Service Ver. 1.0 Apr. 2007
ON
ON
ON
"OFF"
"OFF"
"OFF"