Service Mode; Service Mode Function Setting Procedure; Procedure; Exiting - Konica Minolta BIZHUB 163 Service Manual

5. Service Mode

5. Service Mode
5.1

Service mode function setting procedure

NOTE
• Care must be used to ensure that only the personnel who are involved in service
jobs know the procedure to enter the service mode.
5.1.1

Procedure

1. Press the Utility key.
2. Press the following keys in this order.
3. Stop → 0 → 0 → Stop → 0 → 1
4. The service mode menu screen will appear.
5.1.2

Exiting

• Press the Reset key.
5.1.3

Changing the setting value in service mode functions

1. Select the desired item using [ ▲ / ▼ ] key.
2. Select the setting value using [▲ / ▼ /
3. Validate the selection by pressing the OK key.
4. To go back to previous screen, press the Back key.
5.2

Service Mode function tree

NOTE
• This setting menu contains only the cases in which the AD-504 is mounted.

SERVICE'S CHOICE

5.3

Setting in the service mode

5.3.1 SERVICE'S CHOICE
A. LOOP ADJUST (DUPLEX)
Functions To adjust the length of the loop formed in the paper before the registration roller.
• When a skew feed, fold, or misfeed of paper occurs
Use
• When variations in the amount of void on the leading edge occurs
Adjustment
Setting range: -3.9 to 3.9 mm (1 step: 0.6 mm)
range
Setting 1. Call [SERVICE'S CHOICE] of Service mode to the screen.
procedure 2. Select [LOOP ADJUST (DUPLEX)] and press the OK key.
3. Using ▲ / ▼ key, select the desired setting value.
4. Press the OK key to validate the setting value selected in step 3.
Adjustment Instructions
• Try a different setting value until there are no variations in the amount of void on
the leading edge, and paper skew, fold, or misfeed.
12
/ ] key or the 10-key pad.
Service Mode
LOOP Ad. (DUPLEX)
Field Service Ver. 1.0 Apr. 2007
Ref. page
P.12