Konica Minolta BIZHUB 163 Service Manual page 278

Field Service Ver. 1.0 Apr. 2007
• As is the case with the RSD, operations from the control panel of the local
machine, PC print, and Scanner function are not accepted while a connection is
being established with the local machine using the LSD (Local Setup Diagnostic)
and Page Scope Web Connection/Admin. mode.
• As is the case with the RSD, no connection can be made with LSD and Page Scope
Web Connection/Admin. mode during operation from the control panel of the local
machine. Make the connection while no operations are performed on the local
machine.
B. COMM. SETITNG
(1) TONE/PULSE
Functions
• This function is used to set the dial system of phone which is used by the machine.
Use
Setting/ • The default setting is "TONE".
Procedure
[TONE]: Tone line
[PULSE]: 10 PPS pulse [10pps] line or 20 PPS pulse line [20pps] is selected.
(2) LINE MONITOR
Functions
• This function can be used to set the volume when monitoring communication.
Use
Setting/ • The default setting is "LOW".
Procedure
• Monitor sound output period
Usual TX/ RX
Using On Hook key • Just after pressing On Hook key.
(3) PSTN/PBX
Functions • This function can be used to set whether the connected telephone wiring is a public
switched telephone network (PSTN) or a private branch exchange (PBX). For a PBX
system, the outside line access number (or extension number) must be specified.
• The connected wiring system can be set to either PSTN (Public Switched Telephone
Use
Network) or PBX (Private Branch Exchange). For a PBX system, the outside line
access number (or extension number) must be specified. The outside line access
number (or extension number) is programmed in the [#] key.
Setting/ • The default setting is "PSTN".
Procedure
"TONE"
OFF "LOW"
• Pressing Start key following pressing ten-
key.
• Pressing Start key following pressing
Speed dial.
• Pressing One-touch key.
• Pressing Redial key.
"PSTN"
PULSE
HIGH
Start
PBX
6. Utility Mode
End
After receiving
V21 signal.
After receiving
CED signal.
21