Cleaning Of The Developer Scattering Prevention Plate - Konica Minolta BIZHUB 163 Service Manual

3. Periodical check
3.5.14

Cleaning of the developer scattering prevention plate

A. Periodically cleaning parts/cycle
• Developer scattering prevention plate: Every 40,000 prints
B. Procedure
1. Divide the image unit into the PC drum assy and the developing assy.
See P.20
[1]
26
[1]
[2]
A09AF2C554DA
A09AF2C555DA
Field Service Ver. 1.0 Apr. 2007
2. Remove three screws [1], and
remove the developer scattering pre-
vention plate [2].
NOTE
• When securing the developer scat-
tering prevention plate, tighten
screws in the order of one on one
edge, one at the center, and one on
the other edge.
3. Using a brush, whisk dust and dirt off
the surface of the developer scatter-
ing prevention plate [1].