10. Service Mode
E. ID ADJUST
Functions
• To set the image density by varying Vg and Vb on the engine side.
Use
• Used when the image density is high or low.
Setting/
• The default setting is 0.
Procedure
F. VG ADJUST
Functions
• To adjust image density by varying Vg with changing sensitivities as the PC drum is
used for an extended period of time.
Use
• Used when image problems (fog, void) occur.
• Used when the PC drum unit has been replaced.
Increase the setting value to eliminate void.
Decrease the setting value to eliminate fog.
Setting/
• The default setting is 0.
Procedure
G. FUSER TEMP. (PLAIN)
Functions
• To set the temperature of the fusing roller for each type of paper, thereby making up
for fusing performance that changes with the operating environment or type of paper.
Use
• Used when fusing failure occurs.
• Used when the type of paper is changed.
Setting/
• The default setting is 0.
Procedure
<Temperature table for adjusting fusing temperature for plain paper>
For bizhub 163
Setting value
Main scanning
251 mm or more
2
250 mm or less
251 mm or more
1
250 mm or less
251 mm or more
0 (default value)
250 mm or less
251 mm or more
-1
250 mm or less
118
Paper width
Sub scanning
direction
direction
361 mm or more
360 mm or less
–
361 mm or more
360 mm or less
–
361 mm or more
360 mm or less
–
361 mm or more
360 mm or less
–
Field Service Ver. 1.0 Apr. 2007
-3 to +3
-2 to +2
-1 to +2
Mode selected in SERVICE'S CHOICE
Mode 1
Fusing heater lamp temperature
200 °C
200 °C
200 °C
200 °C
200 °C
190 °C
190 °C
190 °C
180 °C
180 °C
180 °C
170 °C
Mode 3
190 °C
190 °C
185 °C
180 °C
180 °C
175 °C
170 °C
170 °C
165 °C
160 °C
160 °C
155 °C