L2Tp Tunnel Accounting; Table 62: L2Tp Tunnel Accounting (Description) - Alcatel-Lucent 7750 Reference Manual

L2TP Tunnel Accounting

L2TP Tunnel Accounting

Table 62: L2TP Tunnel Accounting (description)

Attribute ID Attribute Name
1 User-Name
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
32 NAS-Identifier
Page 204
Refers to the PPPoE user-name
The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv4.
The address is determined by the routing instance through which the RADIUS
server can be reached:
"Management" — The active ipv4 address in the Boot Options File (bof
address <ipv4-address>)
"Base" or "VPRN" — The ipv4 address of the system interface (configure
router interface system address <address>).
The address can be overwritten with the configured source-address (configure
aaa radius-server-policy <policy-name> servers source-address <ip-
address>).
The physical access-circuit on the NAS which is used for the Authentication
or Accounting of the user. The format of this attribute is configurable on the
NAS as a fixed 32 bit value or a parameterized 32 bit value. The parameters
can be a combination of outer-vlan-id(o), inner-vlan-id(i), slot number(s),
MDA number(m), port number or lag-id(p), ATM VPI(v) and ATM VCI(c),
fixed bit values zero (0) or one (1) but cannot exceed 32 bit. The format can be
configured for following applications: configure aaa l2tp-accounting-policy
<name> include-radius-attribute nas-port, configure router l2tp cisco-
nas-port, configure service vprn <service-id> l2tp cisco-nas-port,
configure subscriber-mgmt authentication-policy <name> include-radius-
attribute nas-port, configure subscriber-mgmt radius-accounting-policy
<name> include-radius-attribute nas-port.
The type of service the PPPoE user has requested, or the type of service to be
provided for the PPPoE user. Optional in RADIUS-Accept and CoA. Treated
as a session setup failure if different from Framed-User.
A string (configure system name <system-name>) identifying the NAS
originating the Authentication or Accounting requests and sent when nas-
identifier is included for the corresponding application: configure
subscriber-mgmt authentication-policy (ESM authentication), configure
subscriber-mgmt radius-accounting-policy (ESM accounting), configure
aaa isa-radius-policy (LSN accounting, WLAN-GW) and configure aaa
l2tp-accounting-policy (L2TP accounting).
7750 SR RADIUS Attributes Reference Guide
Description