Alcatel-Lucent 7750 Reference Manual page 34

Subscriber Host Identification
Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name
26-6527-174 Alc-Lease-Time
26-6527-175 Alc-DSL-Line-
State
26-6527-176 Alc-DSL-Type
26-6527-177 Alc-Portal-Url
26-6527-178 Alc-Ipv6-Portal-
Url
26-6527-180 Alc-SAP-Session-
Index
26-6527-181 Alc-SLAAC-IPv6-
Pool
Page 34
Defines the lease-time in seconds for RADIUS proxy and create-host-CoA
scenarios only. The [27] Session-Timeout is interpreted and used as IPoE lease-
time if [26-6527-174] Alc-lease-Time is omitted. The maximum value
4294967295 corresponds with a lease-time > 9999 days (24855d 03h). Value
zero triggers to fallback to the default lease-time of 7 days. Returning attribute
[26-6527-174] Alc-Lease-Time in other scenarios then radius-proxy and create-
host-CoA are treated as setup failures.
Status of the DSL line obtained via ANCP can be one of three value:
SHOWTIME (the modem is ready to transfer data), IDLE (line is idle) or
SILENT (line is silent). Attribute is included/excluded based on configure
subscriber-mgmt authentication-policy/radius-accounting-policy <name>
include-radius-attribute access-loop-options.
Type of the DSL line (ADSL1, ADSL2, ADSL2PLUS, VDSL1, VDSL2,
SDSL, other) obtained via ANCP.
Attribute is included/excluded based on configure subscriber-mgmt
authentication-policy/radius-accounting-policy <name> include-radius-
attribute access-loop-options.
The URL to which traffic matching the host's IPv4 filter entry with http-redirect
action is redirected to. The URL overrides the configured URL in the redirect
filter. Radius overrides must explicitly be enabled: configure filter ip-filter
<filter-id> entry <entry-id> action http-redirect <rdr-url-string> allow-
radius-override.
The URL to which traffic matching the host's IPv6 filter entry with http-redirect
action is redirected to. The URL overrides the configured URL in the redirect
filter. RADIUS overrides must explicitly be enabled: configure filter ipv6-
filter <filter-id> entry <entry-id> action http-redirect <rdr-url-string> allow-
radius-override.
Per SAP unique PPPoE or IPoE session index that can be included in RADIUS
Access Request messages. The lowest free index is assigned to a new PPPoE or
IPoE session. Attribute is included or excluded based on configure subscriber-
mgmt authentication-policy <name> include-radius-attribute sap-session-
index.
A pool name that can be used in local address assignment to assign an IPv6
SLAAC prefix via a Router Advertisement to the WAN side of the IPoE/PPPoE
user.
Alc-SLAAC-IPv6-Pool names longer than the allowed maximum are treated as
host setup failures. If local-address-assignment is not enabled on the group-
interface for ipv6 client-application ppp-slaac, then the PPP session will be
terminated. If local-address-assignment is not enabled on the group-interface for
ipv6 client-application ipoe-slaac, then the IPoE host will not be instantiated.
7750 SR RADIUS Attributes Reference Guide
Description