Alcatel-Lucent 7750 Reference Manual page 32

Subscriber Host Identification
Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name
26-6527-128 Alc-ATM-Ingress-
TD-Profile
26-6527-129 Alc-ATM-Egress-
TD-Profile
26-6527-131 Alc-Delegated-
IPv6-Pool
Page 32
The ATM Traffic Descriptor override for a PPPoA or PPPoEoA host and refers
to the pre-configured traffic description QoS profile applied on the ingress
ATM Virtual Circuit (configure qos atm-td-profile <traffic-desc-profile-id>).
All subscriber hosts on a given ATM VC must have same ATM traffic
descriptors and this attribute is ignored if it specifies an ATM Traffic Descriptor
override while it has already specified another one for another host on the same
ATM Virtual Circuit. A pre-configured description profile per ATM Virtual
Circuit is used when this attribute is omitted. (configure subscriber-mgmt
msap-policy <msap-policy-name> atm egress/ingress traffic-desc or
configure service vprn <service-id> subscriber-interface <ip-int-name>
group-interface <ip-int-name> sap <sap-id> atm egress/ingress traffic-desc).
A Traffic Descriptor profile above the Limit is treated as a setup failure.
Unreferenced Traffic Descriptor profiles within the Limit, or a Traffic
Descriptor profile for a non ATM host are silently ignored.
The ATM Traffic Descriptor override for a PPPoA or PPPoEoA host and refers
to the pre-configured traffic description QoS profile applied on the egress ATM
Virtual Circuit (configure qos atm-td-profile <traffic-desc-profile-id>). All
subscriber hosts on a given ATM VC must have same ATM traffic descriptors
and this attribute is ignored if it specifies an ATM Traffic Descriptor override
while it has already specified another one for another host on the same ATM
Virtual Circuit. A pre-configured description profile per ATM Virtual Circuit is
used when this attribute is omitted (configure subscriber-mgmt msap-policy
atm egress/ingress traffic-desc or configure service vprn <service-id>
subscriber-interface <ip-int-name> group-interface <ip-int-name> sap <sap-
id> atm egress/ingress traffic-desc). A Traffic Descriptor profile above the
Limits is treated as a setup failure. Unreferenced Traffic Descriptor profiles
within the Limits, or a Traffic Descriptor profile for a non ATM host are silently
ignored.
The name of an assigned pool that should be used to assign an IPv6 prefix via
DHCPv6(IA-PD) to the LAN side of the user (IPoE, PPPoE). Maps to DHCPv6
vendor-option[17],sub-option[2] pfx-pool. Alc-Delegated-ipv6-pool names
longer than the allowed maximum are treated as host setup failures. Alternative
method for [123] Delegated-IPv6-Prefix so simultaneous returned attributes
[123] Delegated-IPv6-Prefix and [26-6527-131] Alc-Delegated-IPv6-Pool are
handled as host setup failures. The length information [DPL] can be supplied
via [26-6527-161] Alc-Delegated-IPv6-Prefix-Length along with the pool
name. The [26-6527-161] Alc-Delegated-IPv6-Prefix-Length has priority over
other possible sources of DPL. (As a fixed or variable DPL under configure
service ies/vprn subscriber-interface ipv6 delegated-prefix-length or on the
dhcpv6 server configure router dhcp6 local-dhcp-server <server-name> pool
<pool-name> delegated-prefix-length).
7750 SR RADIUS Attributes Reference Guide
Description