Alcatel-Lucent 7750 Reference Manual page 37

Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name
26-6527-202 Alc-Dhcp6-
Renew-Time
26-6527-203 Alc-Dhcp6-
Rebind-Time
26-6527-217 Alc-UPnP-Sub-
Override-Policy
7750 SR RADIUS Attributes Reference Guide
The attribute value represents the DHCPv6 lease renew time (T1). T1 is the
time at which the client contacts the addressing authority to extend the lifetimes
of the DHCPv6 leases (addresses/prefixes).
This attribute is applicable only when an IPv6 address/prefix is assigned via
Radius (DHCPv6 proxy). Overrides the dhcp6 proxy-server renew-timer
configuration on the group-interface.
The attribute value is expressed in seconds. Values outside the allowed range
(see limits) result in a setup failure.
If for the final determined values from the different sources (ludb, radius,
defaults), the following rule is violated:
renew timer <= rebind timer <= preferred lifetime <= valid lifetime
then the default timers are used: renew-timer = 30 min, rebind-timer = 48 min,
preferred-lifetime = 1hr, valid-lifetime = 1 day.
Note that only a single value can be specified that applies to both IA-NA
address and IA-PD prefix.
The attribute value represents the DHCPv6 lease rebind time (T2). T2 is the
time at which the client contacts any available addressing authority to extend
the lifetimes of DHCPv6 leases.
This attribute is applicable only when an IPv6 address/prefix is assigned via
Radius (DHCPv6 proxy). Overrides the dhcp6 proxy-server rebind-timer
configuration on the group-interface
The attribute value is expressed in seconds. Values outside the allowed range
(see limits) result in a setup failure.
If for the final determined values from the different sources (ludb, radius,
defaults), the following rule is violated:
renew timer <= rebind timer <= preferred lifetime <= valid lifetime
then the default timers are used: renew-timer = 30 min, rebind-timer = 48 min,
preferred-lifetime = 1hr, valid-lifetime = 1 day.
Note that only a single value can be specified that applies to both IA-NA
address and IA-PD prefix.
Specifies the UPnP policy to use for this l2aware subscriber. The policy must be
configured in configure service upnp upnp-policy <policy-name>.
Overrides the configured policy in the sub-profile for the subscriber: configure
subscriber-mgmt sub-profile <name> upnp-policy <policy-name>.
The value "_tmnx_no_override" removes any existing override and installs the
upnp-policy configured in the sub-profile instead.
The value "_tmnx_disabled" creates a special override that disables UPnP for
this subscriber.
Specifying a non-existing policy results in a host/session setup failure or in a
CoA Reject.
All hosts belonging to the subscriber are affected by a UPnP policy override.
Changing the upnp-policy will clear all existing upnp-mappings.
RADIUS Attributes Reference
Description
Page 37