Alcatel-Lucent 7750 Reference Manual page 15

Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
7 Framed-Protocol
8 Framed-IP-
Address
7750 SR RADIUS Attributes Reference Guide
The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv4. The
address is determined by the routing instance through which the RADIUS
server can be reached:
"Management" — The active ipv4 address in the Boot Options File (bof
address <ipv4-address>)
"Base" or "VPRN" — the ipv4 address of the system interface (configure
router interface system address <address>).
The address can be overwritten with the configured source-address (configure
aaa radius-server-policy <policy-name> servers source-address <ip-
address>).
The physical access-circuit on the NAS which is used for the Authentication or
Accounting of the user. The format of this attribute is configurable on the NAS
as a fixed 32 bit value or a parameterized 32 bit value. The parameters can be a
combination of outer-vlan-id(o), inner-vlan-id(i), slot number(s), MDA
number(m), port number or lag-id(p), ATM VPI(v) and ATM VCI(c), fixed bit
values zero (0) or one (1) but cannot exceed 32 bit. The format can be
configured for following applications: configure aaa l2tp-accounting-policy
<name> include-radius-attribute nas-port, configure router l2tp cisco-nas-
port, configure service vprn <service-id> l2tp cisco-nas-port, configure
subscriber-mgmt authentication-policy <name> include-radius-attribute
nas-port, configure subscriber-mgmt radius-accounting-policy <name>
include-radius-attribute nas-port.
The type of service the PPPoE user has requested, or the type of service to be
provided for the PPPoE user. Optional in RADIUS-Accept and CoA. Treated as
a session setup failure if different from Framed-User.
The framing to be used for framed access in case of PPPoE users. Optional in
RADIUS-Accept and CoA. Treated as a session setup failure if different from
PPP.
The IPv4 address to be configured for the host via DHCPv4 (radius proxy) or
IPCP (PPPoE). Simultaneous returned attributes [88] Framed-Pool and [8]
Framed-IP-Address (RADIUS Access-Accept) are handled as host setup
failures. Attribute is also used in CoA and Disconnect Message (part of the
ESM or AA user identification-key). Attribute is omitted in accounting via
configure subscriber-mgmt radius-accounting-policy <name> include-
radius-attribute no framed-ip-addr.
RADIUS Attributes Reference
Description
Page 15