Alcatel-Lucent 7750 Reference Manual page 102

WLAN Gateway
Table 28: WLAN Gateway (description) (Continued)
Attribute ID Attribute Name
87 NAS-Port-Id
26-3561-1 Agent-Circuit-Id
26-6527-145 Alc-MGW-Interface-
Type
26-6527-146 Alc-Wlan-APN-Name
26-6527-147 Alc-MsIsdn
26-6527-148 Alc-RSSI
26-6527-149 Alc-Num-Attached-
Ues
Page 102
A text string with format defined by the aggregation type:
GRE or L2TPv3: "<tunnel-type> rtr-<virtual router id>#lip-<local ip
address>#rip-<remote ip address>"
where
<tunnel-type> = GRE | L2TP,
rtr-<virtual router id> is the transport service
lip-<local ip address> is the local tunnel end-point
rip-<remote ip address> is the remote tunnel end-point
For example: NAS-Port-Id = "GRE rtr-11#lip-50.1.1.1#rip-201.1.1.2"
VLAN: "VLAN svc-<svc-id>[:<vlan>[.<vlan>]]"
where
svc-<svc-id> is the relative identifier of the internal
_tmnx_WlanGwL2ApService Epipe service connecting the WLAN-GW
group interface SAP to the MS-ISA.
[:<vlan>[.<vlan>]] is the optional dot1q or qinq encapsulation identifying the
AP
For example: NAS-Port-Id = "VLAN svc-1:10"
Agent-circuit-id is transparently taken from the circuit-id in DHCP option-82.
Most WIFI access-points insert information describing the AP and SSID that
the UE is associated with. Recommended format is an ASCII string
containing AP's MAC@, SSID name and SSID type (open or secure), with a
delimiter between each, as shown in example:
"00:00:00:00:00:01;xfinity-wifi;o"
This contains the interface type that will be used to determine the type of
GTP-C connection, overrides local configuration.
Specifies the Access Point Name (APN) for which a GTP-C session will be
set up. This will be signaled in the GTP-C setup and may be used to determine
the IP address of the GGSN/P-GW by performing a DNS query if the [26-
10415-5] 3GPP-GGSN-Address attribute is not present. This overrides a
locally configured APN.
Contains the MSISDN (telephone number) of the UE, and will be included in
GTP-C signaling. When not present the corresponding GTP-C Information
Element will not be sent.
Received Signal Strength Indication. Used in conjunction with the radius-
proxy track-accounting feature. When the radius-proxy receives this attribute
in an accounting message, it will be copied into the DHCP lease state and
echoed by the SROS accounting.
Number of attached WIFI UEs. The attribute is forwarded by the RADIUS
proxy when received in an Access-Request from the AP.
7750 SR RADIUS Attributes Reference Guide
Description