Table 52: Enhanced Subscriber Management Accounting (Description) - Alcatel-Lucent 7750 Reference Manual

Enhanced Subscriber Management (ESM) Accounting

Table 52: Enhanced Subscriber Management Accounting (description)

Attribute ID Attribute Name
1 User-Name
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
7 Framed-Protocol
Page 144
Refers to the user to be authenticated in the Access-Request. The format for
IPoE/PPPoE hosts depends on configuration parameters pppoe-access-
method, ppp-user-name or user-name-format in the CLI context configure
subscriber-mgmt authentication-policy <name>. The format for ARP-hosts
is not configurable and always the host IPv4-address. The RADIUS User-
Name specified in an Access-Accept or CoA is reflected in the corresponding
accounting messages. The attribute is omitted in authentication/accounting via
configure subscriber-mgmt authentication-policy/radius-accounting-
policy <name> include-radius-attribute no user-name.
The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv4.
The address is determined by the routing instance through which the RADIUS
server can be reached:
"Management" — The active IPv4 address in the Boot Options File (bof
address <ipv4-address>)
"Base" or "VPRN"— The the IPv4 address of the system interface (configure
router interface system address <address>).
The default NAS-IP-Address value can be overwritten:
ESM: configure aaa radius-server-policy <policy-name> servers source-
address <ip- address>
DSM: configure aaa isa-radius-policy <name> nas-ip-address-origin {isa-
ip|system-ip}
The physical access-circuit on the NAS which is used for the Authentication
or Accounting of the user. The format of this attribute is configurable on the
NAS as a fixed 32 bit value or a parameterized 32 bit value. The parameters
can be a combination of outer-vlan-id(o), inner-vlan-id(i), slot number(s),
MDA number(m), port number or lag-id(p), ATM VPI(v) and ATM VCI(c),
fixed bit values zero (0) or one (1) but cannot exceed 32 bit. The format can be
configured for following applications: configure aaa l2tp-accounting-policy
<name> include-radius-attribute nas-port, configure router l2tp cisco-
nas-port, configure service vprn <service-id> l2tp cisco-nas-port,
configure subscriber-mgmt authentication-policy <name> include-radius-
attribute nas-port, configure subscriber-mgmt radius-accounting-policy
<name> include-radius-attribute nas-port.
The type of service the PPPoE user has requested, or the type of service to be
provided for the PPPoE user. Optional in RADIUS-Accept and CoA. Treated
as a session setup failure if different from Framed-User.
The framing to be used for framed access in case of PPPoE users. Optional in
RADIUS-Accept and CoA. Treated as a session setup failure if different from
PPP.
7750 SR RADIUS Attributes Reference Guide
Description