Using Ping - Avaya M770 User Manual

Using PING

The M770 ATM Switch allows you to PING an IP address. The M770 ATM Switch
will send one Internet Control Message Protocol (ICMP) echo request to the address
each second until you press CTRL-C. Whenever the remote device responds, the
time taken to respond is displayed in milliseconds.
To PING an IP address, use the ip ping command.
Command:
Example:
Parameters:
Output:
Note: The command will continue to PING. To interrupt it, press CTRL-C.
Avaya M770 ATM Switch User's Guide
Chapter 4
M15-155s8:/>ip ping <address>
M15-155s8:/>ip ping 192.32.220.5
The IP address for the remote device.
<address>
PING: target address is 192.32.220.5
Type Control+C to stop the ping sequence
Response from 192.32.220.5: seq 0, delay 5 ms
Response from 192.32.220.5: seq 1, delay 2 ms
Response from 192.32.220.5: seq 2, delay 2 ms
Response from 192.32.220.5: seq 3, delay 1 ms
Response from 192.32.220.5: seq 4, delay 1 ms
Ping of 192.32.220.5
Packets sent:
Packets received: 5
Managing Miscellaneous Commands
5
35