Clear Screen Command; Ping Command; Show Commands Summary Table - Avaya P333T User Manual

Clear screen Command

The clear screen command clears the current terminal display.
The syntax for this command is:
clear screen

Ping Command

Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host[number]]
host
number
Note: You can use this command via the Master module only.
Example:
To ping the IP number 149.49.48.1 ten times:
Cajun_P330-N> ping 149.49.48.1 10
ping 149.49.48.1 10: 56 databytes
64 bytes from 149.49.48.1: icmp_seq=0. time=8 ms

Show Commands Summary Table

Following is a table of the show commands:
• show time
• show timezone
• show ntp
• show ip route
• show image
version
• show snmp
• show snmp retries
• show snmp timeout
Avaya P333T User's Guide
Host IP address/Internet address of route destination. If missing
then the last host IP is used.
Number of packets to send. If missing then the last number is used
Show current time
Show the current timezone offset
Display the current Network Time
Protocol (NTP) status and parameters
Show IP routing table entries
Show the image version
Show SNMP community strings
Show SNMP retries number
Show SNMP timeout
Chapter 6 Cajun Campus CLI – Layer 2
Page 44
Page 44
Page 44
Page 45
Page 45
Page 45
Page 46
Page 46
41